Well then, hope this little angled extender piece will give you more play options for your Legacy Metroplexes too! Happy 3d printing and love to see what you guys come up with (especially with more sets done up!)

Also, the end caps will need to be super glued into place to hold the clips tightly.

The clips should be printed sideway to give the 'fingers' the ability to bend slightly and not snap.

Once the Junction pieces have been printed, snap on the corresponding ratchets into them and then it may take a bit of strength to force.

Be prepared to snap a couple along the way as again, this is quite challenging to put together.

Due to the strength and stiffness required for the parts, it is recommended to print them with more walls/infill.

Once these are set in place, the peg will hold everything together. The attached diagram shows the parts for this build and how they go together.įor the front and back junction, once their ratchets are insert, are to be somewhat forced fit into place. Now attached, the drill buckets can be further extended and angled downwards to the ground! And of course, lifting it right off the ground into a stowage mode is now possible too!Īnd never one to miss the chance with presented, this piece also comes with a bunch of 5mm ports for more blasty goodness to be added on!

In any case, then put together, it should look something like in the attached photos, with the inner ratchet pieces able to hold the arms at specific angles.Īnd now, to connect the extender to other parts of Metroplex, just do the clippity thing similar to how the other pieces connect up. ** A word of warning though - this is a fairly challenging piece to print and assemble and once the two halves are connected, will be hard to separate. Here's the third piece of upgrade for Legacy Metroplex - an articulated extender piece for Sparkdrinker to allow his drill buckets to reach the floor or be angled upwards in his alt mode!

Download legacy metroplex